How to change the Honing Head

The process of replacing the Honing Head requires careful operation to ensure dimensional accuracy and equipment safety, roughly as follows:

1. Preparation stage:

Disconnect the power supply and ensure that the honing machine is completely shut down.

Prepare new grinding head and necessary tools.

Refer to the manual for replacement procedures and precautions.

2. Disassemble old Honing Head:

Unscrew or lock the device.

Gently remove the old grinding head to avoid damaging the machine interface.

3. Check and clean up:

Check the installation interface and clean it if necessary.

Clean the new Honing Head mounting surface to ensure assembly accuracy.

4. Install new grinding head:

Align with the installation position and slowly screw in or push in.

Tighten the screws using a torque wrench to ensure proper tightening.

5. Adjustment and verification:

Put in the workpiece and start the gas measurement to observe the indicated value.

Adjust the size as needed, and use an external cylindrical grinder to "gauge" if necessary.

Always follow the Honing Head manufacturer's specific guidelines and safety specifications.